Nothing (visible on-screen) happening after network_print_config

[SKubajko]

Probably worth mentioning that I installed the ISD chip myself (it's a 360E). Both power and eject sounds work, so I'm pretty sure the connections are okay, at least it looked fine

Any idea what can be causing this (other than hardware)?

[buddyjojo]

It's waiting for a response from the ISD, it'll just freeze there if it can't properly communicate with it.
Are the SB gpio resistors going to the ISD populated? (R2C21, R2C25, R2C23, R2G5, R2P5 + the pullups)

[SKubajko]

Yea just checked them, all fine, then I did a proper reflow and it works INSTANTLY. Sorry for wasting your time, never trusting my hot-air skills again :)