[BUG] DD Conversion, z axis falls to bed after print.

[BeauMyGoodness]

Did you test the latest release build?

Yes, and the problem still exists.

Bug Description

I deleted M84 from my end G-code to see if that gets it to lock the Z in place after print, but it still seems to go into idle mode immediately after print finishes and z axis falls to the bed.

I understand going DD can cause this as well, but I'm wondering if there's a way I can set the motors to not disable after a print in the control screen, or even the HC32 Configuration.h and I can compile myself.

Firmware File

HC32_BLT-ProUI-EX-07-13.bin

Printer Model

Voxelab Aquila

Model Type

X2

Your Mainboard or Chipset

Aquila HC32

Other Mainboard Type

No response

Add-ons that could be involved

No response

ProUI-EX | Extra Features?

Yes

Bed Leveling

BLT - BL Touch Bilinear mesh

Did you include your own configuration files?

• A ZIP file containing your Configuration.h and Configuration_adv.h.

Additional information & file uploads

Printing via Pronterface and USB.

[BeauMyGoodness]

link to video showing what's happening on print end.

[Mik-S-UMS]

Its not a problem with the FW but that your gantry is too heavy so is not held in place when the motors are turned off.
Unfortunately you cannot tell one motor to stay enabled and turn off the rest as all the enables on the PCB are tied together, it is all or nothing.

I can't remember if the steppers are automatically disabled by the FW after a print or if that is in the end Gcode. Might be better to home X and move the bed out to allow you to remove the print but keep the motors enabled with M17.

Another thing could be the Z axis is too loose so not enough friction to hold it up, tightening the eccentric nuts a little can help as long as it can still move freely.